Tennessee TDOSHS CDL General Knowledge Practice Test 2
Test 2 of 5. Pick an answer for each question to see if it is right and why; your score appears at the end. You need 40 correct answers to pass, the same ratio as the real Tennessee test.
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age21 years
-
1. You are told a posted bridge ahead has a weight limit lower than your gross weight. What must you do?
Show answer
Answer C: Take a route that avoids it, because a posted limit is a legal limit
A posted structure limit must be obeyed exactly as any other weight limit, so a heavier vehicle has to be routed around it.
-
2. What should you do with the previous driver vehicle inspection report before starting your trip?
Show answer
Answer B: Review it and confirm that listed defects were certified as repaired or as not needing repair
Reviewing the last report and the carrier certification tells you whether reported defects have been corrected before you take the vehicle out.
-
3. Which parts of total stopping distance can a driver shorten simply by staying alert and looking far ahead?
Show answer
Answer B: Perception distance and reaction distance
Alertness shortens the time spent recognizing a hazard and moving your foot to the pedal; braking distance depends on speed, weight, brakes and the road surface.
-
4. An intermodal container is being carried on an ordinary flatbed rather than on a container chassis. What does that mean for securement?
Show answer
Answer B: It must be secured with tiedowns that meet the container securement requirements
A container carried on a vehicle that is not fitted with integral locking devices has to be secured to the deck with tiedowns that satisfy the rules for containers.
-
5. During the vehicle overview, what should the driver look for on the ground under the vehicle?
Show answer
Answer B: Fresh puddles of oil, coolant, grease or fuel
New stains on the ground are the earliest sign of a leak, so the overview includes a look underneath before anything is opened or started.
-
6. Why should you avoid using your lights to tell a following driver that it is safe to pass you?
Show answer
Answer B: You may misjudge the gap and the driver will act on your signal
The manual warns against signaling others to pass, because the responsibility for a head-on crash then rests on a judgment you could easily get wrong.
-
7. Under federal rules, what is required of a commercial driver who wants to use a mobile phone while driving?
Show answer
Answer B: The phone must be hands-free and started with no more than a single button press, and it must not be held
Federal rules ban texting and hand-held phone use while driving a commercial vehicle; reaching for, holding or dialing a phone is a violation.
-
8. How many points does a commercial driver receive on an ordinary road for texting while driving a commercial vehicle in Tennessee?
Show answer
Answer B: 3 points
A commercial driver's base texting violation on an ordinary road is assessed at 3 points, matching the non-commercial penalty.
-
9. Which components on a typical engine are driven by belts that must be checked for wear and tension?
Show answer
Answer D: The alternator, the water pump and, on many vehicles, the air compressor
Belts drive accessories such as the alternator, the water pump and the air compressor, so one failed belt can take out charging, cooling or air supply.
-
10. How does the eight year state fee for a Tennessee Class A commercial license compare to a Class B or Class C commercial license?
Show answer
Answer A: Class A costs 70 dollars; Class B or C costs 62 dollars
Tennessee prices the broader Class A commercial license at 70 dollars, while a Class B or Class C commercial license costs 62 dollars, both for an eight year term.
-
11. Why does a cracked frame rail or cross member make a vehicle unsafe?
Show answer
Answer B: The frame carries the whole load, and a crack can spread until the structure fails
The frame is the backbone that supports the body, the load and the running gear, so a crack in it is a structural failure that grows with every mile.
-
12. What is the risk when too little weight rests on the drive axles?
Show answer
Answer A: Poor traction, so the drive wheels spin easily on wet or slippery surfaces
Traction depends on weight pressing the driving tires onto the road, so a light drive axle spins on wet, snowy or loose surfaces.
-
13. What are you looking for when you check the hubs and wheel seals during the walkaround?
Show answer
Answer B: Leaking oil or grease, which can also contaminate the brake linings
A leaking hub seal starves the bearing of lubricant and the escaping oil or grease can soak the brake linings and cut braking power.
-
14. Why should a driver avoid stopping partway up a snow covered hill?
Show answer
Answer D: You may not get moving again and could slide backwards
On a slippery grade the drive wheels may simply spin when you try to restart, leaving the vehicle stuck across the road or sliding back down it.
-
15. During uncoupling, when may the fifth wheel locking lever be released?
Show answer
Answer D: Only after the landing gear is down and taking the weight of the trailer
The landing gear has to be supporting the trailer before the lock is released; otherwise the trailer nose can drop as soon as the tractor pulls out.
-
16. Why should the radio, the fan and other noisy equipment be switched off during a required stop at a railroad crossing?
Show answer
Answer C: So that an approaching train can be heard
The rules require the driver to look and listen along the track, and on a double track crossing a passing train can hide a second one, so hearing matters as much as seeing.
-
17. Which windshield condition should be reported during the inspection?
Show answer
Answer B: Cracks or dirt that get in the way of your view of the road
The windshield must give a clear view; damage or grime in the driver line of sight is a safety defect.
-
18. Rust streaks are running outward from the lug nuts on one wheel. What does this most likely indicate?
Show answer
Answer C: The lug nuts may be loose
Rust trails spreading from the nuts are a classic sign that the nuts have worked loose and the wheel has been moving on the studs.
-
19. Before starting a trip, what must the driver confirm about the weight of the loaded vehicle?
Show answer
Answer A: That it is within the legal gross and axle limits for the route being driven
Overweight vehicles brake poorly, damage tires and suspension components, and can be put out of service at a scale, so weight is checked before the wheels turn.
-
20. You have stopped and a pedestrian is waiting to cross in front of your truck. Why should you not wave the person across?
Show answer
Answer C: Another driver may not stop, and your wave sends the person into danger
You cannot control what drivers in the other lanes will do, so you should not invite a pedestrian into a lane you do not command.
-
21. Which items belong to the trailer part of the walkaround inspection?
Show answer
Answer D: Landing gear, doors, tires, wheels, lights, reflectors, frame and cargo securement
The trailer has its own running gear, lighting, structure and load, and all of it is the responsibility of the driver pulling it.
-
22. Why is driving much slower than the rest of the traffic dangerous?
Show answer
Answer B: Other drivers must keep passing you, which creates conflicts
Traffic that has to work its way around you produces lane changes and closing speeds, which is why a large speed difference is itself a hazard.
-
23. You must leave the vehicle parked on a slight grade. What adds security beyond setting the parking brake?
Show answer
Answer D: Chocking the wheels so the vehicle cannot roll if the brake bleeds off
Chocks hold the vehicle mechanically and are the standard backup whenever a parked vehicle could roll.
-
24. Which set of maneuvers makes up the basic control skills part of the commercial driving test?
Show answer
Answer D: Straight line backing, offset backing, parallel parking and alley docking
The basic control skills test is carried out off the road and consists of low speed exercises such as straight line backing, offset backing, parallel parking and the alley dock.
-
25. What is the correct order for a double clutch downshift?
Show answer
Answer D: Release the accelerator and push the clutch to reach neutral, release the clutch and press the accelerator to raise engine speed, then push the clutch again and select the lower gear
A lower gear turns faster than the one being left, so engine speed has to be raised in neutral before that gear will engage cleanly.
-
26. You find a defect during the pre-trip inspection. What must happen before the vehicle is driven?
Show answer
Answer C: It must be repaired, or the vehicle must not be driven
Writing a defect down does not make the vehicle safe; a defect that affects safe operation has to be corrected before the trip starts.
-
27. Loading heavy freight on top of lighter freight has what effect on the vehicle?
Show answer
Answer B: It raises the center of gravity and makes a rollover more likely
A high center of gravity lets the vehicle tip more easily in curves or during a sudden swerve.
-
28. Which steering system findings count as defects during the inspection?
Show answer
Answer C: Bent, loose or broken column parts, arms, drag links or tie rods, and missing nuts, bolts or cotter keys
Every joint and fastener between the steering wheel and the tires carries the driver commands, so looseness or a missing retainer can end in a complete loss of steering.
-
29. Your drive wheels start to spin and the rear begins to slide while you accelerate on a slick surface. What should you do?
Show answer
Answer B: Stop accelerating and, if the vehicle has a manual transmission, push in the clutch
An acceleration skid ends when the drive wheels stop pushing, so easing off the throttle and disengaging the clutch lets them regain grip.
-
30. How long must a Tennessee commercial learner permit be held before the skills test can be scheduled?
Show answer
Answer B: A minimum of 14 days
Tennessee lets an applicant book the CDL skills test only after the commercial learner permit has been held for at least 14 days and the required training is complete.
-
31. You need to check your route on a navigation device. What is the correct approach?
Show answer
Answer D: Set it before the trip or after you have parked
Route programming is planning work, and it belongs to the time before the wheels turn or after the vehicle is safely parked off the roadway.
-
32. How does a front tire failure usually feel to the driver?
Show answer
Answer D: The steering suddenly becomes heavy and pulls to one side
A failed front tire loads the steering and makes the wheel feel heavy, while a rear tire failure shows up as the back end swaying.
-
33. What is the purpose of an escape ramp on a mountain grade?
Show answer
Answer C: To stop a runaway vehicle without injuring the driver
Escape ramps use soft material or a steep upgrade to bring a vehicle with failed brakes to a controlled stop.
-
34. You are given a ratchet strap with a deep cut along one edge. What should you do?
Show answer
Answer C: Do not use it; a damaged tiedown cannot be relied on to hold its rated load
Cuts, burns, knots and broken stitching weaken a strap far below its marked working load limit, so it must be taken out of service.
-
35. Why should water never be used on an electrical fire or a gasoline fire?
Show answer
Answer C: It spreads the fuel and conducts the current
Water carries current back to the person holding the hose and floats burning fuel outward, which is why a B:C rated extinguisher is carried instead.
-
36. Under federal rules, which commercial vehicles must stop at every railroad crossing before proceeding?
Show answer
Answer D: Passenger buses and placarded hazardous materials vehicles
Buses carrying passengers and vehicles required to display hazardous materials placards must stop at crossings, while other commercial vehicles slow and check.
-
37. What must the driver check about the seat belt during the inspection?
Show answer
Answer A: That it is securely mounted, adjusts properly and is not ripped or frayed
A belt only restrains the driver if its anchorage is sound and the webbing is intact, so mounting and condition are both checked.
-
38. Apart from the risk of stalling, why is rolling backwards when starting on an upgrade so serious in a heavy vehicle?
Show answer
Answer D: You can strike the vehicle behind you, which is often much closer than you think
You cannot see how close the vehicle behind has stopped, and even a short roll back is enough to hit it.
-
39. When must a driver first inspect the cargo and its securement devices?
Show answer
Answer C: Before starting the trip, as part of the pre-trip inspection
Cargo is part of the pre-trip inspection; the later checks within 50 miles and every three hours or 150 miles come on top of that first inspection.
-
40. At a rest area you find that the load has shifted although the straps still feel tight. What should you do?
Show answer
Answer C: Correct the load before driving on, since a shifted load is no longer secure
Movement means the securement has already failed once, and a load that has shifted can shift again, so it is put right before the vehicle moves.
-
41. A dispatcher tells you to take a trailer you believe is loaded badly enough to be unsafe. What should you do?
Show answer
Answer C: Refuse to move it until the load has been made safe
The driver may not operate a vehicle whose cargo is not properly distributed and secured, and an instruction from an employer does not change that.
-
42. How do objects appear in a convex mirror compared with a flat mirror?
Show answer
Answer B: Smaller and farther away than they really are, while a wider area is shown
A convex mirror shows a wider field but shrinks everything in it, so the driver must remember that vehicles are closer than they look.
-
43. A sign before a long descent shows 6 percent. What does that number tell you?
Show answer
Answer A: How steep the grade ahead is
Percent grade is the drop in feet for every hundred feet of road, so the higher the number the faster speed will build and the lower the gear you need.
-
44. How should a commercial driver treat the speed posted for a curve?
Show answer
Answer B: As a limit set for cars in good conditions, so a heavy or tall load calls for a lower speed
Posted curve speeds are based on passenger vehicles in good conditions, and a tall or heavy load can roll over well below that speed.
-
45. You are backing into a yard where electrical wires cross overhead. What is the main concern?
Show answer
Answer C: The wires may hang lower than the top of your vehicle
Overhead space has to be checked like any other space around the vehicle, because wires and cables are often lower than they look from the cab.
-
46. How do you get more engine braking from an automatic transmission on a downgrade?
Show answer
Answer B: Select a lower range before starting down
Locking the transmission into a lower range keeps engine speed high enough to hold the vehicle back and spares the service brakes.
-
47. Why must the driver of a large vehicle keep it centered in its lane?
Show answer
Answer B: The vehicle needs the full width of the lane
A commercial vehicle is close to lane width already, so any drift takes part of the vehicle into the next lane or onto the shoulder.
-
48. While checking the in-cab gauges after start-up, what should the coolant temperature gauge do?
Show answer
Answer C: Rise gradually to the normal operating range
A healthy cooling system warms the engine slowly; a gauge that shoots up or stays cold points to a problem with the thermostat, coolant or sensor.
-
49. During the walkaround you notice a bulge in the sidewall of a trailer tire. What does it indicate?
Show answer
Answer B: Damage inside the tire, which can lead to a sudden failure
A bulge means the internal structure has broken and only the rubber is holding the air, so the tire can burst without warning.
-
50. Which exhaust system condition must be reported as a defect?
Show answer
Answer B: A section repaired by wrapping tape or patching material around the pipe
Exhaust parts may not be patched with wrap or tape, because the repair does not contain the gas or the heat and it fails quickly in service.